Noisy garage door and tune-ups in Ho-Ho-Kus

Most garage doors get no maintenance at all until the day they stop. A yearly check costs far less trouble.

Call (551) 262-1824

In short

For a noisy or jerky garage door in Ho-Ho-Kus: lubricate hinges and rollers, keep the tracks clean, and have the balance and springs checked once a year. Worn rollers are the usual cause of noise and are quick to replace.

Inside of a double garage door with a torsion spring above it

Wear and weather in Ho-Ho-Kus

On the west side of Ho-Ho-Kus, older and detached garages have doors on mixed hardware in frames that have shifted. East of Route 17, large doors on three-bay garages are heavy and need their balance checked yearly; landscapers' blowers push dust and clippings into the tracks every week of the growing season. Along the Saddle River and near Brewster Pond, flooding has left rust in bottom brackets and lower track bolts. Damp low ground keeps spring coils rusty. Route 17 salt comes in on tires all winter. The borough is quiet enough that a grinding door is heard down the street. A fall tune-up is the right interval; flooded garages should be checked after each high-water event.

What the noise is telling you

  • Squeaking or squealing: dry hinges, rollers or springs. Usually a lubrication job.
  • Grinding or rumbling: worn rollers, or steel rollers with failed bearings.
  • Popping as the door moves: spring coils binding, or a section joint that needs attention.
  • Rattling or vibrating: loose hinge bolts, track brackets or a slack opener chain.
  • A bang: not a noise to tune away. Stop using the door; a spring or cable may have failed.

A five-minute check, twice a year

  • Watch the door open and close once. It should move smoothly and stay level.
  • Listen for anything new.
  • Lubricate hinges, rollers and springs lightly. Keep lubricant off the tracks and off nylon roller wheels.
  • Wave a broom through the sensor beam while the door closes. It should reverse at once.

If the door fails the reverse test, or you see a frayed cable or a gap in a spring, stop using the opener and call.

What happens during maintenance

Balance test, spring adjustment, hardware tightened, rollers and hinges checked for wear, cables checked for fraying, tracks cleaned and aligned, everything that should be lubricated is, and the opener's safety features are tested. Swapping noisy steel rollers for nylon ones is the single change that quiets most doors. Nothing is replaced without your say, and the price comes first.

Around Ho-Ho-Kus

  • Brook side: Streets along the Ho-Ho-Kus Brook through the center of town.
  • West side: Near the station and downtown, with older colonials and detached garages.

See the full Ho-Ho-Kus service area.

Leave the door where it is and call.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 262-1824
Call (551) 262-1824