Garage door won't close: sensor repair in Ho-Ho-Kus

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (551) 262-1824

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Ho-Ho-Kus repairs the sensors and re-tests the opener's safety system.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Ho-Ho-Kus

Ho-Ho-Kus is small, about four thousand people. On the west side, near the station and downtown, older houses have detached or narrow attached garages with sensors on aging wood. East of Route 17, homes sit on an acre or more, with three-bay garages and long driveways lined with trees. Along the Saddle River frontage and around Brewster Pond and the brook, low ground is damp, and after high water sensors and wire ends corrode. Landscape crews are a weekly presence on the east side, and blown leaves and mulch in the doorway are routine. A light that flickers in wet weather points to corrosion.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Ho-Ho-Kus

  • Brewster Pond area: Large properties near the pond on the east side.
  • Brook side: Streets along the Ho-Ho-Kus Brook through the center of town.

See the full Ho-Ho-Kus service area.

Leave the door where it is and call.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 262-1824
Call (551) 262-1824